Instructions for Replacing Retractable Registration Pins
You will need a soft mallet and a small screwdriver.

1. Remove existing registration pin from die if necessary.

• Place die FOAM SIDE DOWN on padded or soft surface. Raise an edge of the die near the pin to be replaced so there is room for the pin to eject.
• From the wood side of the die, tap the pin using a screwdriver and soft mallet until it comes out the foam side of the die.

2. Insert new registration pin.

• Place the die FOAM SIDE DOWN on padded or soft surface.
• From the wood side of the die, insert the pin with the narrow retractable end first. Tap the flat end of the pin into the die using a screwdriver and soft mallet until it is flush with the wood.